KITS START FROM $299.00
No items in your cart

Inscreed Heating

This system is best suited for wet area applications, for example bathrooms & laundry’s where you simply lay the heating element (cable) and your tiler screeds over the top. Inscreed heating enables you to use almost any type of floor covering eg. graphite, marble, natural stones and tiles. Inscreed heating is an economical way of heating the whole room. Warmtech brings you a new dimension in affordable, luxurious, effective heating which is simple to operate and maintenance free.

Warmtech inscreed under floor heating system’s are the perfect solution for any wet area application including the bathroom & laundry. We provide a 5mm thick electrical element that is laid on top of waterproofing, ready for you tiler to lay his bed of sand & cement over the top (generally 20-50mm thick dependent on fall). In the kit you will receive;

  • Pre-configured element on a reel (size as purchased)
  • Analogue thermostat MTC-1991-WU
  • Adhesive spray
  • Adhesive tape
  • Element alarm tester (with batteries)
  • Full installation instructions

 

Brief Installation Process

In 99% of situations, a 20-60mm sand cement screed needs to be laid over the electrical element so there is a medium between the heating element & the flooring.

It is extremely important to install the floor sensor in the heated area as the thermostat needs to be set to measure and regulate the floor temperature. The maximum heat as specified by the manufacturer is normally 27 degrees celsius. The thermostat will not regulate and adjust from the floor element itself to your specified programmed temperature if the floor sensor is not installed in the heated floor area. Please call us if this is not done, as we can help you switch the thermostat over to an air sensor instead.

Need new tiles to cover your underfloor heating?

Eliane Tiles offers a stunning collection of high quality floor, bathroom and outdoor tiles. Visit their website for all of your tiling needs!