Floor Heating Products



Inscreed Heating

This is an efficient form of underfloor heating which enables you to use almost any type of floor covering available eg granite, marble, slate or terracotta. The inscreed heating cable is suitable for installation in concrete screeds and can also be used internally beneath thick stone floors or externally under pathways.

 

Inscreed heating is a low cost solution and our heaters are designed to be used where regular constant heat is required. The heaters consist of a fixed length of heating wire terminated at one end by a sealed joint and the other end by a 3m power supply cable (cold tail). The cores and earth braid are spliced in a waterproof joint assembly to the supply conductors and the earth conductor of the cold tail. The table below gives you a brief despcription of the heaters.

 

 

These heating cables are installed and then covered by the sand and cement mixture before tiles are laid. The heating cables are close to the tile surface so the response and heat up time is very quick and efficient.

 

These heating cables consist of twin conductors (single ended) for ease of installation and are perfect for those suffering from asthma. The Inscreed cable is a quick response form of heating and is suitable for almost any type of flooring including granite, marble, limestone, terracotta, porcelain & ceramic tiles. The Inscreed heating cable is suitable for installation in concrete screeds and can also be used internally beneath thick stone floors or externally under pathways.

 

The wattage density of the floor can vary depending on the application and the area to be heated but is typically 170 watts/sqm.

 

All heating elements are factory terminated and are available in set lengths - 7 different sizes.

Although some tilers are quite happy to lay directly over this, we recommend a thin bedding to protect the cable and provide a better working surface.

 

We also offer complete inscreed heating kits which comprise of everything you need to install the heating cable. The kit includes:

  • Warmtech Inscreed heater
  • Adhesive spray
  • Adhesive tape
  • Analogue thermostat
  • Continuity alarm tester
  • Installation manual


 

Free Underfloor Heating Information

Why the maths?

We have to ask you a maths question to prevent spamming by bots, it helps us to provide a better service and response to you.

Thanks
The Warmtech Team

Bookmark with Warmtech Australia








Home   |   Support   |   About Warmtech   |   Contact Us

Why Underfloor Heating?   |   Why Warmtech?   |   Gallery   |   Floor Heating Products   |   Brochures and Technical Downloads